Gels, Gobos, Lighting Fixtures & Hardware
Show
per page
« Previous Next » 1 2 3 4
Used to mask light leaks and to conceal unsightly cabling. Use it outdoors for weather protection. It is the ideal material for making a snoot to shape a beam of light or barndoors to control spill. In film and video work, shiny surfaces which cause unwanted glare.
You can construct your own lighting tree using the bases listed
You can also construct your own tree using the lightweight Ultimate Support components listed
Two-Fers and Three-Fers are available with no connector, stage pin grounded(GP) or twistlock grounded (GL)
Rubber cable leads
These small rugged adaptors are of unibody construction and factory wire
Due to the high heat emitted by lighting instruments, special heat resistant leads are used to feed power into the back of the lighting fixture
Prices are per 40" lead with eyelets
Three leads plus a Glass woven sleeve (36" long) equal one instrument
The accessory Strain Relief is suggested for the 20 amp connector when undersized cable is used
It is ideally suited for use with the sleeved leads common to many lighting fixtures
The tough polycarbonate clamping device will accept cable sizes up to
The most secure connection available, but very expensive
Old - nib out configuration
Grounded 3 pole connectors
Amp: 20
The only 15/20 amp connector that locks on ground pin
Ground 3 pole connectors
Volts: 125/250
Amps: 15/20
With these light strings you can duplicate the brilliant effects of the chase strip lighting seen on theatre marquees
Each chaser strand comes with a controller for that strand length and molex connector
If you need longer lengths, contact a sales rep
They may be pipe or tree mounted and are perfect for tight spaces where conventional rackmount dimmer packs are too bulky
With both male and female XLR connectors, the control switch may be daisy-chained from pack to pack
DMX or analog
This clever patented handle will definately make life easier for all
The Handle fits onto the existing bolt found on pipe clamps therefore eliminating the need for a wrench
The Handle can be repositioned easily if you need to use a wrench
And since
This gooseneck lamp is used for turntables, preamps, keyboards, music stands, lecterns, mixers, lightboards, clip boards, and anywhere you need a light light
Both sets include base and dimmer
6 foot cord, wall plug-in transformer, gooseneck.
The SPEC-6 will create realistic fire effects, the light of an old-time movie screen, TV tube flicker, candlelight, and gaslight
An infinite number of special effects are available with either strobe or flick-slow pulsing light to extremely rapid flutter
30" long so it will fit any light fixture
When a "C" clamp fails, a #LH2230 safety cable will stop a light from hitting an actor's head
Our C-clamp is designed the way C-clamps were supposed to be... shaped like a "C"
The top of our C-clamp extends further than most others so it stays hooked to the batten even if it loosens
Fits 1 1/2" & 2" pipes
A lightweight framing spotlight incorporating a 2.00" optical system designed to produce narrow to medium beam spreads up to 15 feet away
Ideal for architectual and display applications due to the lamps long life, low cost and low voltage
Included are
« Previous Next » 1 2 3 4