Curtain Track, Curtain Hardware & Stage Fabric

Used where large safety pin is needed, such as pinning back soft goods

4" in length

Made of wrought steel and a nickel plated finish with a sturdy spring snap
Easy way to hang curtains

Made of blunt wrought steel with a plain finish

Made of wrought steel wire with a plain finish

Made of forged steel
Will cut clearance holes for corresponding size grommets

Made of dropped forge steel
Will set sheet brass or teeth grommets

VELCRO® is a registered trademark of Velcro Industries B.V.

Pressure sensitive only
Roll size: 25 yds.

Ceiling and wall brackets are used where it is impractical to support tracls in usual manner from chain or cable
Each type is attachable to track hanging clamps
Constructed on high gauge steel

Ceiling and wall brackets are used where it is impractical to support tracls in usual manner from chain or cable
Each type is attachable to track hanging clamps
Constructed on high gauge steel

"Made of wrought brass
Packed with washers

This steel Fireproof unit is used on the majority of stage installations with medium to light weight curtains on lengths up to about 36'.

On heavier installations, Models 171N or 171R can be used. These tracks are identical to Model 170 except with nylon or neoprene ball bearing carriers are supplied.

Clip through to order parts and accessories.

This steel fireproof unit is used on the majority of stage installations using heavy weight curtains of any length and is particularly quiet in operation
Models 281, 282 are for use with particularly heavy curtains.

For use on ceiling-mounted installations
Adjustable to any location
Top plate is mounted first, then channel is installed
Recommended spacing: 5'

Same as #CT1458 but without ball bearing wheel and it is always placed on dead end pulley track section on inside of curve

Bracket includes ball-bearing wheel for guiding cord around curve
Always placed on dead end pulley track section on outside of curve
Minimum pocket width to accomodate spindlers and idlers: app. 16"

Lock plate for joining and extending track sections assuring proper vertical and horizontal track alignment
8" long x 1" wide

Used with Model 142 track, 2 per job
Block constructed of steel supported from 4 nylon-tired ball-bearing wheels

Consists of steel tubing including two ball-bearings for guiding cord around curves
Also has ball-bearing wheel for guiding return cord
Always placed on Live End Pulley track section on inside of curve

For accurate bending of the channel
Designed for screw fastening on floor for on-the-job-curving

Same as #CT4201 except block constructed of steel supported on 2 nylon wheels
Used on Model 140-R, 141-R, and 142-R

Attach to pipe with pipe clamps for most rigid bracing
Adjustable to any location
Recommended spacing: 4' (also at splices and on curves)