Theatrical & Set Hardware
Show
per page
Ceiling Plate
Ceiling Plate with Ring
Forged eye bolt with a large ring
Used in place of standard forged eye bolt when you need a bigger eye to accommodate wide rope.
Used on the side rails of flats, jacks, or platforms to pin them down
Size: 8"X 1"X 1/4"
Designed as top iron on the side rail of the flat or throughout the flat
Available in long
or short
or new version (that's rated)
Lighter thickness then other mending plates
This plate has 49 holes drilled in it for your convenience
Size: 3 1/8" x 10 15/16" (or just make it 11")
Very handy!
Used on flats, jacks, or platforms when a variable angle for pinning down is needed
Size: 8"X 1"X 1/4"
Steam line interlocking action designed to support heavy loads
Each piece is the same so they are not frustrating to work with.
Two pieces is one unit.
Designed to be used on the lower rail of flats when scenery is to be above ground
Size: 6"X 1"X 3/16"
Used to stabilize two or more flats
Designed to fit 7/8" X 3" wooden batten
One of the most common problems on stage is how to quickly brake and then release rolling scenery. Wagon Brakes provide secure holding power, as well as fast, quiet releasing without the need for drilling holes in the stage floor. Mounted to the side of a platform or scenery, this brake actually lifts the scenery off its casters, preventing the wagon from shifting under active actor movement. A unique lever action pushes down a plunger, lifting even heavy pieces with only minimum force required for a stagehand. A minimum of two brakes per unit are recommended.
Hardware made specifically for holding framed pictures.
Use with #H2201 Picture Socket
Hardware made specifically for attaching to frames or boards as a catch for hooks.
Use with #H2200 Picture Hook
Made of fine tinned wire
Will support heavy loads
Five pound coils