#140 Rig-I-Flex
Show
per page
For use on ceiling-mounted installations
Adjustable to any location
Top plate is mounted first, then channel is installed
Recommended spacing: 5'
Same as #CT1458 but without ball bearing wheel and it is always placed on dead end pulley track section on inside of curve
Bracket includes ball-bearing wheel for guiding cord around curve
Always placed on dead end pulley track section on outside of curve
Minimum pocket width to accomodate spindlers and idlers: app. 16"
Lock plate for joining and extending track sections assuring proper vertical and horizontal track alignment
8" long x 1" wide
Used with Model 142 track, 2 per job
Block constructed of steel supported from 4 nylon-tired ball-bearing wheels
Consists of steel tubing including two ball-bearings for guiding cord around curves
Also has ball-bearing wheel for guiding return cord
Always placed on Live End Pulley track section on inside of curve
For accurate bending of the channel
Designed for screw fastening on floor for on-the-job-curving
Same as #CT4201 except block constructed of steel supported on 2 nylon wheels
Used on Model 140-R, 141-R, and 142-R
Attach to pipe with pipe clamps for most rigid bracing
Adjustable to any location
Recommended spacing: 4' (also at splices and on curves)
A versatile I-beam track which has been engineered for both curved (model 140) and straight (model 141). It was especially designed for heavy duty stage and TV studios and for enclosing areas in industrial plants.

